DLE Engines DLE 30CC Gas RC Aircraft Engine for RC Plane Model Engine DIY

DLE Engines DLE 30CC Gas RC Aircraft Engine for RC Plane with Electronic Ignition and Mufflers

This DLE Engines DLE-30cc gas rc airplane engines is a gas rc plane engine. The gas rc engine is electronically ignited, comes with mufflers. Easy to get start. Besides, this rc plane engine is protected by a 2-year limited warranty. 

* DLE 30CC Gas Engine
* spark plug
* four standoffs
* muffler
* gasket
* two 5x20mm muffler bolts
* four 5x60mm mounting bolts
* instruction manual

SPECIFICATIONS
Output Power: 3.7 HP at 8,500 RPM
Idle Speed: 1,600 RPM
RPM Range: 1,600-8,500
Static Thrust: 8.5kg Pulling Force/100 meters altitude 7.5kg Pulling Force/1,800 meters altitude
Displacement: 1.86cu in (30.5cc)
Bore: 1.42″ (36mm)
Stroke: 1.18″ (30mm)
Compression Ratio: 7.6:1
Crankshaft Thread: 5mm
Weight: Engine, 2lbs (910g); Muffler, 2.1oz (60g); Ignition, 4.2oz (120g)
Gasoline/Oil Mixture: 30:1
Gasoline Octane Rating: 87
Recommended Propellers: 18×8 for break-in, 18×10, 19×8, 20×8
Spark Plug: CM6 Carburetor Adjustments;
Low Speed Needle: 1.5 turns out as a starting point, adjust for a smooth idle and a reliable transition to high throttle
High Speed Needle: 1.5-2 turns out from closed, adjust needle to peak RPM, if engine slows or dies at full throttle, the high-speed mixture is likely too lean
Distance Between Mounting Hole Centers Same Side: 2.1″ (54mm)
Distance Between Mounting Hole Centers Opposite Side: 2.7″ (70mm)
Height from bottom/Crankcase to top of Cylinder Head: 5.4″ (138mm)
Width of Cylinder Head: 2.5″ (65mm)
Distance Between Muffler Mounting Hole Centers: 1.3″ (34mm)

REQUIREMENTS
* Gasoline with at least 87 octane rating
* 2-cycle oil, mix ratio for this engine is 30 parts gas to one part oil and must be followed exactly for warranty consideration and optimum performance
* 4.8 – 6V NiMH/NiCd, or 6.6V LiFe or 7.4V LiPo battery for ignition (separate receiver style pack can be used)

NOTE : 1st version ignition is marked ‘A-01’ on the label and requires a regulator if using 2S LiPo/LiFe battery. If ignition module is the A-02 model it has a built-in voltage regulator. Model A-02 designation is located above the word “Ignition” on top of the case**

FEATURES
* Two sealed bearings on crankshaft-simple design for lighter weight
* Aluminum alloy crankcase
* Rear mounted pumper carburetor ensures easier installation and smooth idling and dependable fuel flow during flights
*  Fully automatic electronic ignition Ignition Sensor available separately