DLE Engines DLE-35RA 35CC Gas RC Aircraft Engine for RC Plane with Electronic Ignition and Mufflers Engine DIY

DLE Engines DLE-35RA 35CC Gas RC Aircraft Engine for RC Plane with Electronic Ignition and Mufflers

The DLE Engine DLE-35RA gas rc airplane engines is a 35cc gas rc plane engine. The gas rc engine is includes a newly designed piston with re-engineered skirt for less piston weight – resulting in such advantages as awesome throttle response, more power and longer engine life. This gas rc engine can produce 400 more rpm than the DLE30, the DLE-35RA comes with engine standoffs, electronic ignition, spark plug and muffler.

FEATURES
* High performance in a compact package
* Rear exhaust for the perfect tuned pipe setup
* Newly designed piston with re-engineered skirt for less piston
* weight resulting in such advantages as awesome throttle response, more power and longer engine life
* Electronic ignition is the no-hassle answer to simpler starts, higher performance and minimal RF noise **Ignition Sensor
* Producing 400 more rpm than the DLE30, the DLE 35-RA comes with engine standoffs, electronic ignition, spark plug and muffler

SPECIFICATIONS
Displacement: 34.5 cc (2.13 cu in)
Bore: 1.5 in (38.5 mm)
Compression Ratio: 7.6:1
Static Thrust: 9.5kg Pulling Force/100 meters altitude
7.8kg Pulling Force/1,800 meters altitude
Gasoline/Oil Mixture: 30:1
Gasoline Octane Rating: 87
Recommended Propellers: 18×10, 19×8, 20×8, 20×10
Weight, engine: 2.06 lb (936 g)
Weight, muffler: 2.61 oz (74 g)
Weight, ignition module: 5.26 oz (147 g)
Output: 4.1 hp @ 8,500 RPM Carburetor Adjustments;
Low Speed Needle: 1.1 turns out as a starting point, adjust for a smooth idle and a reliable transition to high throttle
High Speed Needle: 1.5 turns out from closed, adjust needle to peak RPM, if engine slows or dies at full throttle, the high-speed mixture is likely too lean
Muffler Dimensions: 3.6 x 2.3 x 1.3″ (92 x 58 x 33mm)
Exhaust Outlet Length: 1.9″ (48.5mm)
Exhaust Outlet Diameter: 0.63″ (16.1mm)
Distance Between Mounting Hole Centers Same Side: 2.1″ (54mm)
Distance Between Mounting Hole Centers Opposite Side: 3.1″ (80mm)
Height from bottom/Crankcase to top of Cylinder Head: 5.4″ (138mm)
Width of Cylinder Head: 2.5″ (65mm)
Distance Between Muffler Mounting Hole Centers: 1.6″ (40mm)

REQUIREMENTS
* Gasoline with at least 87 octane rating
* 2-cycle oil, mix ratio for this engine is 30 parts gas to one part oil and must be followed exactly for warranty consideration and optimum performance
* 4.8 – 8.4V battery for ignition (separate receiver pack can be used)

NOTE : 1st version ignition is marked ‘A-01’ on the label and requires a regulator if using 2S LiPo/LiFe battery. If ignition module is the A-02 model it has a built-in voltage regulator. Model A-02 designation is located above the word “Ignition” on top of the case**

INCLUDES
* DLE 35-RA Gasoline Engine
* Electronic Ignition
* Muffler
* DLE CM6 Spark Plug
* Four Engine Standoffs with Mounting Hardware
* Integrated Choke Rod Guide
* Rear-mounted Carb
* Instruction Manual